Composite control pipe machine-welded pipe（tube mill） unit needs to be adjusted regularly
The welded pipe unit is the most critical part in the production of welded pipe. Whether the welded pipe unit is normal or not is related to the normal operation of production and operation, which is related to the quality of the production products and the production efficiency of the enterprise. Therefore, Xiaobian reminds you that the welded pipe unit should be regularly adjusted.
The welded pipe unit must be adjusted before assembly, but after a period of operation, it needs to be adjusted regularly.
The adjusted welded pipe unit can smoothly complete the production work, ensure product quality and ensure the efficiency of the enterprise. So what do you need to do to regularly adjust the crew work? Compound control pipe machine, professional pipe machine.
The most important part of the adjustment of the welded pipe unit is to make regular adjustments to the rolls. It is necessary to ensure that the center line of the hole type of all the vertical rolls, squeeze rolls, sizing rolls, forming rolls and the like is kept in agreement with the center line of the unit. In-plane.
In the production molding process, the center line of the strip steel and the center line of the welded pipe unit are always coincident to prevent the strip from running off. It is necessary to ensure that the strip can pass through the forming units in succession, and when the strip enters each unit, it is necessary to ensure that the roll ring of the forming roll cannot scratch the strip. Stainless steel decorative control pipe machine, professional pipe making machine manufacturer, pipe making machine manufacturer.
How to make the tube machine last longer
Want to make the machine last longer, not only to buy good quality, but also to play a very important role in the later maintenance. The following small series will give you a few tips on the maintenance experience of the pipe making machine.
1.Always check the oil level on the fuel tank. The oil level should not be lower than the specified value.
2.When the fine oil filter is blocked by dirt, it needs to be replaced in time; when the coarse oil filter is blocked, it should be cleaned in time, once every 3 months.
3.To add oil to the fuel tank, it must be filtered. The oil should not be mixed with impurities such as moisture, rust, metal shavings and fibers.
4.When starting the oil pump in winter or cold area, it should be opened and stopped, repeated several times to increase the oil temperature, and then start working after the hydraulic pump station is running flexibly.
5.All the knobs on the hydraulic pump station, non-operators should not move.we are tube mill manufacturer and tube mill supplier ,you can know it.
6.Always observe if the power supply voltage is abnormally fluctuating and check it every 3 months or so.
In fact, the correct maintenance of the pipe making machine in the later period is crucial to the goodness and longevity of the pipe making machine. Therefore, we must insist on maintenance.